Like I said, lot’s of catching up to do!
I’ve got to go back to 5 weeks ago and bring you all up to speed on the progress of the COMET. She was a MESS before we went to Tiny House Summer Camp, but if you saw the article on Deek’s website, you saw some pictures of what she looks more like now – less of a mess.
Anyway, here’s the first installment of catching up the website to where the COMET stands now.
Some serious demolition. After stepping around the back and almost falling through the trailer floor onto the pavement 3 feet below, we decided to replace EVERYTHING. This demolition was made 10 times easier by the use of the SoniCrafter, using the plunge-cut blade to remove rotten wood to where it was solid again.
We cleaned out all of the wood-dust (used to be framing) and insulation from the floor. Under the floor, above the chassis, is a layer of sheet metal for protection. Everything had been destroyed by the termites/carpenter ants and water damage.
Daylight is never a good thing!
The photos above show where we removed the original rotted out 1 x 1 (yes, 1 x 1) framing from that rear of the trailer to halfway under the door frame. We had to remove up to the next joist after the wood became solid, so that we could have something to screw the new subfloor into. We removed the floor framing, then, using the SoniCrafter, we cut the wall studs at a line 5.5 inches above the metal trailer frame. We decided to replace the old 1 x 1 framing with a big 2 x 6, hence the 5.5″ height.
Spongey floor spots, be gone!
The solution was to replace the rotten frame piece with a 2 x 6, so that we were rebuilding the trailer better than it was originally built.
This 2 x 6 is the length of the beam we just removed and is marked to be notched out for the framing around the door frame, which we wanted to save.
We knocked it into place with a few hammer swings and it fit like a charm.
We ended up shimming a bit of this, but it fit nicely for the most part, and we didn’t have to rebuild the door frame!
Bolting the new frame piece to the chassis. The 2 x 6 is notched so the drill bit would reach the top, because it wasn’t 5.5″ long.
View from interior, all bolted in down the line.
Sistering on some new floor studs/joists.
Reframing around the wheel-well for the new subfloor.
I was a happy camper by the end of this little part of it. Next, we re-framed the entire back, raised the rear bed up 6 extra inches, re-insulated with the denim insulation, and more! More pictures of that part soon.
Oh, and all the lumber I used is FSC certified
As always, thanks for reading!
If you like the blog and would like to help me continue working on the COMET, please consider making a small donation over at the DONATE page of this site Thanks!!